BMW 318i E30 Workshop Repair Manual - Manual de Taller With L4 1.8 Lts. M42 Dohc Engine It has 1.529 pages in pdf format. We have Repair Manuals for others BMW models, ask by Message.
Page 2
Crankshafts are marked with yellow, green or white paint depending on main-bearing-journal tolerances.
Bearing shells are marked with yellow, green or white paint.
1 = Bearing shell 1-2-3-4-5 (5 only cap)
2 = Bearing shell 4 (thrust bearing, only crankshaft)
Check grinding size of main-bearing journals!
Installing procedure:
Only place bearing shells with 'yellow' colour code in the crankcase (regardless of paint mark still on the crankcase).
Install 'yellow-green-white'
Install 'yellow or green or white' bearing shells in bearings caps depending on the crankshaft bearing journal colour code mark.
Installation:
Ensure that the oil spray jets are used at bearings 2 ... 5.
RA Replacing crankshaft - crankshaft removed (M42)
BMW AG - TIS
22.01.2013 00:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
< PREV PAGENEXT PAGE >Page 1
1131091
Removing and installing or replacing chain tensioning device (M44)
Note:
The hydraulic chain tensioner (M44) can also be fitted to the M42.
Unfasten screw plug and remove hydraulic chain tensioner.
Note:
The hydraulic chain tensioner can also be removed if the timing-case cover is removed.
Installation:
If a hydraulic chain tensioner is reused, the oil chamber in the tensioner unit must first be drained.
Fasten the hydraulic chain tensioner into vice with protective vice jaws.
Installation:
Slowly and carefully push the hydraulic chain tensioner together, leaving the lock washer (2) still visible.
Repeat this procedure twice.
RA Removing and installing or replacing chain tensioning device (M44)
BMW AG - TIS
06.02.2013 21:20
Issue status (12/2007) Valid only until next DVD is issued